If the programming and configuration files downloaded to the device are not working properly because the device is bound with another computer or for other reasons, you need to perform a factory reset. Once the operation is complete, the original configuration and programming files in the device are cleared off. You need to re-configure and program them at the tool end.

Factory reset

  1. Power off and restart the controller.
  1. After the RUN LED on the controller flashes yellow, press and hold down the SVC button until the RUN LED starts flashing yellow again after turning off for four seconds.
  • At this point, the factory reset starts. The RUN LED flashes green rapidly after the reset is successful.
  1. Download configuration and program files to the device.