To add the detector to the hub
- Add the detector to the hub from the mobile application "Connected Home" following on-screen instructions.
To reset the detector to factory settings
- See LED indication.
To remove battery insulation before using the detector for the first time
- Detach the instructive insulation label from the back cover.
- Twist the back cover of the detector gently using a tool, e.g., a coin, to the unlock position and remove the cover.
- Tear off the battery's insulation sheet.
- Put back the cover and twist it to the lock position.
To replace battery
- Twist the back cover of the detector gently using a tool, e.g., a coin, to the unlock position and remove the cover.
- Remove the old battery and insert a new one.
- Put back the cover and twist it to the lock position.
- Dispose of the exhausted battery in compliance with environmental requirements.
Water leakage indication on the detector
After the detector detects water leakage, it buzzes for 2 seconds, followed by silence for 1 second, and then another two-second buzz within the first 3 minutes, no matter whether water leakage stops or not.
If the leakage continues after 3 minutes, the detector buzzes for 2 seconds every 5 minutes for 12 times in total.
If the leakage continues after the 12-time buzzes, the detector stops buzzing.
The detector stops buzzing immediately when the leakage stops after the first 3 minutes.
Go to the mobile application for more operations such as assigning the detector to a room and viewing monitoring records on water leakage.