To access the configuration user interface, follow the instructions below:
Only the 2-port Ethernet switch supports a local connection to the Connect X200. LAN and WAN in different networks must have different subnets.
- Connect the X200 to the local network your PC / notebook / panel or controller is connected with. Use port 1A or 1B.
- Power on the device.
- Press the SVC button (3) and wait for the SVC LED to illuminate red.
- Open a new browser window.
- In the browser address bar, type the following IP address: 169.254.169.254.
- The network patching configuration should look as follows:
- Combined network: LAN in 2-port Ethernet switch (1A or 1B)
- See Choosing network mode and configuring settings for more information
- The Connect X200 landing page opens.