• Select 'Line Detection (ALL): Get last values for all lines' from the measurement type selection field.
Values of the last measurement cycle

Parameters

Description

'RMS'

Voltage of the pilot tone in [V]

'Impedance'

Magnitude of the complex impedance |Z| at the pilot tone frequency in [ohms]

'SNR'

Not valid

'State'

State of the speaker line, e.g., OK, BREAK, SHORT…

'EOL3'

IDs of the detected EOL, if a sweep was started

'Nominal Pwr'

Load of the speaker line at 1 kHz in [W]

'Phase’

Phase angle of the speaker line at 1 kHz in [deg]